Esko Towa PowerGrab Katana Cut Resist Glove

Description

Certifications

EN 388:2003

The standard for certifying protective gloves against mechanical risks. The numbers under the shield represent (L to R) resistance to abrasion, cut (coup test), tear and puncture.

EN 388:2016

Updates the EN 388:2008 standard. It continues the previous test’s methods with some alterations including a change to the way the coup cut test is carried out (the second figure giving the coup cut resistance rating may be expressed as ‘X’ if the glove is not tested under the coup test or if the rolling blade becomes blunt before the test is completed). It adds a fifth letter (A to F, with F being highest) for cut resistance using the sliding blade TDM test and a sixth letter to indicate impact protection, expressed as ‘P’ for pass. If the glove is not designed to provide impact protection the sixth figure is left out, or sometimes ‘F’ (fail).

EN 407

The standard for gloves to protect against thermal risks. The numbers indicate the glove’s performance for (1) material fire properties, (2) contact heat, (3) convective heat, (4) radiant heat, (5) small splashes, and (6) large quantities of molten metal. The higher the number the better the performance.

ANSI 105-2016 (A4)

The American ANSI cut protection classification for gloves. The numeral represents a ten-point scale, 0 to 9 (lowest to most cut resistant), based on the weight in grams needed to cut through the glove material with 20 mm blade travel in the TDM test.